Recent content by Didde

Thanks! that’s just the type of laminate I’m looking for, it was a lot closer than I thought!

I have one already, but a synthetic one, I know a company close to me that have a high detail 3D scanner and I’ll try to make them do a 3D scan. Otherwise use pictures and make a close copy, but it’s hard to use free forming tools in fusion to make a “close copy” The plan is to make a laminate...

Hey! I am working on a project to make my own Wildcat stock. I have built my own CNC Router and will soon complete a 4th Axis, and I wonder if anyone might happen to have 3D files of the Wildcat stock? I have asked FX if they release files but get no answer, could of course make my own model...

That’s the dimension I’m looking for, I was dumb enough to modify it before taking measurements, I’m also looking for overall dimensions, 

That hole from inside at the back of the pushrod to flush 

You have to measure from the back of the block. It is the hole closest to the cheek rest (upper) “the pushrod pin guide hole” there’s 3 holes in diagonal orientation at the back. Measure out to flush with the block, and the 4th hole is where the hammer tension spring and adjustment screw is...

Hello everyone! My English isn’t the prettiest, but I hope you all understand anyway, I’m not entirely sure that I’m in the right place on the forum for this kind of post but I hope so. I have a little problem with my wildcat.. the charging/loading handle set screws went sliding on the...