Recent content by Dckoch

I am happy to email my 3d file for printing if anyone would like it. I cannot take credit for the original creation someone named Brock shared it on thingsverse. I have just taken the file and continue to refine it. Please send me a private message with your email and I will send out both...

Felix Thank you for the shout out. I continue to refine the stock adapter for the HW44. Here are a couple of screen shots of my latest design changes. Thank you, David

This listing has been renewed

This listing has been renewed

Looking for a 30 Caliber barrel set up for a BRK (Brocock) Ghost. Please let me know what you may have for sale. Thank you in advance. David

All thank you for the Advice. I did buy the pistol from AOA and they are in my backyard. I was hoping there may be a website to order replacement parts I was unaware of. I was just trying not to do the "Walk of Shame" into the store so Kip could make fun of me. Thank you all. David

I broke it trying to modify it. I had added a stock (Early Thread here) to the rear of the gun with epoxy puddy and picatinny rail Somehow my Son broke it off. So I tried to heat up a small picatinny rail and melt it to the rear. I melted right through the rear of the gun when I tried to...

I broke the lower on my Weihrauch HW44 .22 lower. Wonder if anyone knows if it is possible to order a replacement? Any help is appreciated. David 

Ok, Well I sanded down the JB weld. Probably a little to much. Really need a belt sander. Hand sander and rasp probably not the best tools for the job. Remounted rail. Still have a little gap below and above rail but more flat or level. Not bad for an amateur. Mount is strong and does not...

Another Idea would be to adapt a Beretta 93R Stock to the pistol grip. There use to be a few aftermarket stocks in the Airsoft world not sure anymore. I Have not look at this adaptation but the wired drawing from Dave Larson above jogged my memory. It but may be possible. There are also...

I was not trying to hijack this thread. But onto phase 2 to build up the rear end to create a flat surface. Bought some JB Weld putty for plastic. I have attached to the lower, shaped it and I will let it harden. Once cured, I file and sand it to create a flush surface and reattach the rear...

So prototype is done. Need to figure out a way or built up the rear end on the back of the HW44 so the Rail sits flat /flush (No angle). Even with a couple of washers I cannot get it all the way flat. I am not sure if you could build a mold around the back and fill with epoxy and make a flat...

Ok - So I got a wild hair and started prototyping my own system. Basically I am using the Sig MPX pistol as my example. IF you are unfamiliar the rear of the gun has a five Slot picatinny rail machined into the rear. This allows the user to customize his arm brace with between folders...

I have both a 177 and 22 in the HW44. The guns are very accurate but the addition of a stock would make them more stable. The stock is a great idea but i wish it was not so bulky and could side fold. It would be great if you could adapt a stock like this:

Does any one know if this is coming in a synthetic stock set? With its look I think it would be better suited for a synthetic or aluminum chassis. David