Daystate DeltaWolf .30 caliber, 700cc tank, 2 magizines, PRS butplate w/monopad, PRS trigger front rail, “0” db Moderator, single shot magazine. Daystate original case NOT case shown! Found a slow leak. I $1500.00 shipped UPS Conus only
I’m see similar results in reverse also and don’t have an answer. Probably something I’m doing. Just a point of information I have noticed. When you set your Zero on the scope, if you’ll use 37 yards for zero set all your corrections will be “UP” except for in environmental factors. Seems to...
I don’t know where the previous owner bought it but my Delta Wolf has the 700 bottle. Try best fittings for the valve, that’s the label on my Impact 700 bottle valve.
Thanks Hawkeye for sending the information I did not have. CT apparently assumes that everybody has everything. The gun was updated when it was in for service. These data files are only available if you load the program. Didn’t load the program cause I don’t have a program loader. I like how...
How about giving more information as to how these threes selections affect each other. this way we have a better understanding of what we‘re doing and get a more balanced setting. Going in blindly like this is, let’s just say not fun!
ctairguner1288, how about telling me and others how you went about creating and saving your custom profiles. I with someone would make a video of tuning the Delta/Alpha Wolf. I my case the .30 caliber.
I miss when almost all post in all forum categories also showed up on the general post page or should I say I thought is was that way. I very will might be incorrect! Seems like I miss a lot of interesting post now.
No response under barrel forum so. Ran a cleaning mop down the 30 caliber barrel attached to a cleaning rod that I attached a tape indicator. Pull it out 13” (could have been 13.25”) and got 180 degree rotation, times 2= 1 in 26 barrel twist rate. Has anyone measured a different twist?
Thanks ghoststranger169, it’s interesting that StrelokPro loads the .22 NSA 30 slugs with G1 as the coefficient index for them. I also wonder why nobody has taken the time to mention it here?
Ran a cleaning mop down the 30 caliber barrel attached to a cleaning rod that I attached a tape indicator. Pull it out 13” (could have been 13.25”) and got 180 degree rotation, times 2= 1 in 26 barrel twist rate. Has anyone measured a different twist?