Recent content by daryl

Pics sent to email

I use 28 gauge wads. I use a razor knife to cut off the domed cup on the bottom. For hunting i fill them with #4. You can get 3/4 to 7/8ounce in the wad then the scotch tape over the end. I have the smaller choke and get 12 inch patterns at 25-30 yards. I dont think you would have any problems...

I have one! I live here in ohio. I took it out for its first real hunt two week ago. Got a couple rabbits. It took me three trips to the range, a homemade rear sight, some home made shells and a hundred clay pigeons to get dialed in. Two shots and two kills! One was 30 yards and the other about 20.

The vent rib will make a big difference. I had to modify a cheap scope ring for a rear sight for it to shoot even be close to the target .. it was shooting a foot and a half low looking down the barrel but its all good now..12 in spread at 25 yards dead center..

I have the first edition. I use a 28 gauge shot cup for loads. Just cut off the bottom cup and use the top half of the wade. You can get 3/4 to 7/8 of shot in a standard wad then scotch tape the top. Last time i took it to the range i was better than 50% taking out clay pigeons with #8...

Is the big bore still available?

I am interested. Pm sent.