Recent content by darkcharisma

The valve has multiple exhaust ports instead of one large port. This design should be less efficient then the 1 port. Too many directions and gaps to fill before hitting the pellet=loss of pressure and less fps. Same with fx pellet probe styles vs pin probes. More efficient with pin probes...

No, the pressure tube of this m60 doesnt flow through to the valve, it hits a regulator and the regulator flows to the valve via a 11mm hole by 240mm long. You can only add plenum to the regulated side but this one doesnt have alot of options. Only through the gauge port. Its probably unsafe...

3 business days! Excluding weekends

Sooooo. I got the M60. I knew the plenum space was going to be small. but i didn’t expect it to be only min 20cc or max 23cc. The inside hole is only 11mm diameter and about 9.5 to 9.8 inches deep. The bigger inside diameter is occupied by the removable valve. The type that I don’t like with...

its available on some of europeans websites. I am about to get one for opn surgery

Hi guys Jaydog has several Mavericks listed for sale. i inquired and we talked over the phone. he is known as Jared and I am Duy. Jared told me he would email a paypal invoice the night before. i checked, did not see so texted him to send me an invoice next morning. invoice came over and i...

Hello people! I been pursuing power and saw some limitations and power loss from the impact. so I said screw it, I am gonna fix it all with a balance valve. Right now the valve is pushing 700mm 25 cal 38.5gr slugs 1025fps at 150bars. it is pushing it with wheel on MIN and valve stop gap at...

My crown 380mm doesnt have a slug liner and i am shooting NSA 17.5gr@925fps to 100 yards. the slug gets pushed around at 100 yards. but at 50yards its a laser. I would not sell my Crown. I would buy a Powerpup with slug liner

The plenum for Avengers are 15cc. It would run $20 off 2 bills. I dont know if it's worth investing if you are not gunning after power.

you already did something similar and know the answer. why would ya hesitate now? as long as you dont go over 80% of the caliber size and debur the hole. should be good

It looks like a plenum I made or could make.

Nick that's a pretty wood stock!!! I also wanted to find out what the plenum looks like.

I do remember the Artemis P12 can be filled past the 2900psi mark as I have read on the GTA forums. BUT...The big BUT is I don't do it or advise people to do it. IT is fking "PRINTED" 2900psi fill for a reason!!! The P12 uses the P15 airtube, so the manufacturers claimed. But Please dont...

If you are not confident in taking it down. Send it to FX. But if you are willing to take it down. It does not need to be taken all the way down. you just need to take off the rear block and valve housing. Rifle need to be degas.

Wow? that is all you have to say? Let me add.... WOW, He's obviously never talked to any Phd, Dr, or nurses, or his dad. obviously he's had more knowledge than anyone that was born before him.