Recent content by Cybergrizzly

Yes, you are correct. However, sometimes ii is best do it like that to learn something. LOL Thanks again for the help.

Got it out. Had to partially disassemble the trigger action and a couple things but it worked out. Thanks.

Will do. Thanks.

Ohhhh, ok. Now I get it. I thought the valve retaining nut was screwed to the action block and was only there to stop the valve from moving rearward. The retaining nut is actually screwed to the valve body. Perfect. Got it. Will work on it. Thanks a lot. You've been of great help. God...

Does the valve guide pin needs to be removed?

Yes, already did that but it didn't work.

Great !!! Good instructions. Will follow. Just one stupid question. If the valve body is just pressed in and held in place with the 2 o-rings, why do I have to remove the valve retaining nut if you can simply hit the the valve body with a dowel pin thru the retaining nut hole ? Is it to...

Hi, Folks. I am usually good at repairing airguns of all kinds, but got stuck with a Benjamin Bulldog. It appears that there is an air leak coming from the transfer port. I replaced the valve stem with a new one. Air still comes out from the TP. Cocked the lever while filling the gun...

Great !! Thank you.

I have seen several FX Impacts with a black cylinder attached where the regulated air gauge is attached to the rifle and then the gauge is relocated at the other end. Obviously, the cylinder/tube provides additional plenum space for more regulated air volume. Does anyone know who sells those...

How is the accuracy in .22 and .25 compared to the OEM FX Royale counterparts ? What kind of velocities are you achieving and with which pellets ? Was it worth the investment and effort ? I know I am doing it just for fun and to find out if the STX barrel is better than the ST.

Glem. Did you widen the barrel transfer ports all the way as if the .22 and .25 were .30 caliber or just enough to reach the valve transfer port?

STO: The idea of the reamer is good but bear in mind that 13.75mm is the diameter of the barrel end that actually enters the action block and fits snugly to be fixed with 3 set screw grubs. If I would to use a reamer to deepen 5/8" long the action block hole to 14mm, one set screw would...

That is the back of a .30 cal STX fully disassembled. A lot of glue was on the threads, and it needed a lot of heat to undue.