Recent content by Cutler

Once you have done all of the above, fit a barrel tuner to the end of the barrel and shoot groups on various settings until you get the setting that gives the best group then lock the tuner in that position. But this is the last hurdle, do the stuff above first.

I have thought about it a lot as a benchrest shooter. In my opinion it is when a few factors act together. Your gun might have small percentage difference in speed if you shoot over a chrony, then your pellets might differ a small amount in weight, then there might be light gush of wind just as...

Rather go Heliboard. Less expensive and easier to program.

A lot has happened since my last post in 2020, Almost 3 years on. I have a second Heliboard that I fitted to my new Redwolf Safari, and I dumped the Poly barrel for a 3 groove Benchmark barrel, to use as my 100 meter gun at unlimited competitions. I have dabbled a bit with slugs, I bought a...

I am sure they would pressure check the cylinders to way above what we pump them, but if it makes you feel uneasy have Krale change the gun, as for the poor reg performance I would just put a Huma in. The P35 is a low budget gun and if you want it to perform flawlessly you need to upgrade some...

I just love my Red Wolfs, have 3 of them! Also love my Uragan 1 .22 and my RAW TM1000 in 20cal. Very accurate. Then surprisingly I also shoot my Snowpeak P35 a lot, magic "truck gun"

I bought several Carm mags for my Redwolfs, Uragan and P35 Snowpeak, also single loaders for these rifles, all work faultlessly. You cannot go wrong.

I have Heliboards in 2 of my Redwolfs, they are great, not only for FAC type power but also sub 12 ft/lb, they have 12 settings and every one of those is almost infinitely adjustable too, so the sky is the limit. It turns a Daystate Redwolf into a super gun. You can go from 6ft/lb to 60 ft/lb...

The rifle is a winner, but it comes down to the marksman in the end. Well done Henry!

When you input the correct weight of the pellet it will read the correct ft/lb. I have made the same mistake before!

Just got my third Redwolf......

+1000

I noticed exactly the same on my .177 18Ft/lb Redwolf, so I changed the O-ring in the barrel (in my case 4x1,5mm) and it still blew the tissue away. Will try it again with the single load tray, that should block the air from the mag indexing pin.

I bought a .22 P35 because that caliber was the only one available in South Africa, but I have since modded it heavily. I straight away fitted a riser rail on the top so that I could get my scope high enough, it also has height adjustment so you can shoot the scope optically centered. I have a...

On my P35 I re-barrelled with an old FX .177 barrel back when they still used LW barrels. Polished it as well as cut a thread on the end to take a moderator. Then fitted a Huma regulator and a larger plenum. Also fitted a riser block to the picatinny rail that is adjustable for height. Playing...