Recent content by CoyoteGod

.30 caliber. Hades and Diablo pellets. No slugs.

Love those Uragans. Have first gen and second gen. Going to probably get a gen 3. Can’t go wrong with them especially shooting pellets.

Yep, almost grabbed it off the classifieds, but just have too many Airguns. Wallet versus inventory wasn’t balanced correctl.

I think just about everyone is sick of carrying around their $2000 FX Airgun likes it’s made of glass. It’s time to move on to other just as good options and let money make FX get back to the design table.

Many city’s or counties have their own ordinances against Airguns specifically. Have to watch out for that. Can be big big fines.

I, as many on the forum was was also an LCS early adopter before all the Western drama. I found the LCS to function fantastic, design was great, scope above bore distance - TERRIBLE, accuracy was below average and unacceptable even for hunting standards. Never used the full auto. Semi auto was...

Many local dealers do or have someone that does cerakoting and it’s pretty cheap nowadays. It’s fairly easy to do and do a good job for simple coating designs (three color pattern or less) so many can do it. I would do that if the Duracoat self apply doesn’t interest you. Duracoat is a great...

I have two .25s, one being one of my favorite Airgun. To be honest though it would be so even if it was a .22 or .30 caliber because of the guy that built it for me. Very special to me. I do enjoy the .25, I use it for smaller game often. I mostly own .30 calibers with different tunes for...

Excellent! Im so glad that RTIs original stack sequence is still a good option. Your Airgun is shooting well!

Damn you figured me out.

Exactly right. This is great advice.

Could be (())( to end the stack but not fully sure on the mora. But RTI has been pretty consistent on all of their generations. Weird that there isn’t a schematic on the mora reg online that I can find.

I believe RTI regulator washers are (())(())(()) following this pattern until done.

Ok great this gives me more info to look in to this further. Thank you.

Impact rebuilds aren’t bad. Can go quick but recommend taking your time. Measure your valve rod distance for your gun. make sure you note washer stack sequence for regulators. Take your time with the O-ring placements so nothing gets clipped. Use only brass or plastic picks so you don’t scratch...