Recent content by corny

model is missing the cross hole to connect the two chambers. I have to drill tap my block. And machine the square hole in the chassis. Otherwise, it’s been working well, no leaks so far

The harder 90buna cut much easier in the grub screws. But I could be wrong. Possibly if they were tighter it could improve the situation. I tried 12x1 buna90 and they just cut to pieces

Order 11x1 and 10x1. I believe he told me 11x1 but I use 10x1 Make sure to get them on the softer side. Buna70 These oring are a bit of a pill to slide into the action because the grub screw holes mess with them as they slide past. I find it much easier to loosen the moderator set screw and...

The price was also reduced It used to be $18.99 per package

They reduced the quantity per package as well as the price per package. They do run decent sales for unlimited quantities a couple times a year. Earlier this year they had 20% off for a month.

I have the identical gun but standard length….its the best bull pup I’ve owned

Two guns I feel confident carrying in my truck, in hot or cold weather….fully expecting them to hold zero. Raw hmx 1000 .22 custom short barrel. taipan mutant .22 huma reg.

Was going to say….raw gauge have a bit of an oring groove or land on the back. I really wish somebody would come of with a higher quality gauge that maintains the size of the oem gauge. I have zero interest in electronics on my guns

Emmm, guess I thought removing the check valve in the bottle would tell you if it’s the check valve that hanging up?

Well, you could trying filling it without the bottle check valve installed? Or u could remove the quick fill check valve too?? So if the guns holds air. Could bleed it all out though the bleed on the larger fill tank? Obviously all u would need it 500-1000 psi so you have an idea where and if...

Is it not taking air? Or not retaining the air once it’s pressurized?

Bought a spare some time ago. No oring in the actual valve assembly

They use a progressively wound spring. I’ve never attempted to install it incorrectly. But it’s highly likely it compresses differently if installed incorrectly. Not sure if that would result in variables though. Does you assembly include the intertia weight and spring? Inside the hammer?

I actually did it to build a custom bolt-on plenum. But even after machining out the action to .8” which is larger than how raw ships them. I could only squeeze 33cc out of This is calculating only the plunum volume minus the threads. So yeah the reg and the valve guts farther reduce this.

I modeled the blocks in solid works. The early models are 18cc the later model are 29cc Minus the poppet, and valve retaining spring and peg