Cloud9AG's latest activity

FT Match Report Arlington Sportsman’s Club 09/27/2025 Welcome to the ASC FT September 2025 match report. The temps were a little cooler...

ASC has 30 naturally painted targets out for our FT match tomorrow. There are several that are black crows and buzzards or gray rabbits...

Good afternoon everyone, ASC will have our next FT match tomorrow Saturday September 27, 2025 (the 4th Saturday of the month) starting...

One week left until the 2025 FT Nats! I can't wait. See you there. Jeff

Don’t forget to have the hammer as slick as possible. Minimal lube and highly polished . This keeps it as consistent as possible. I...

Is .050” too small of a gap or too big? The reason I ask is because 1mm is smaller than .050”, and you said that is a good starting place.

You don’t need an aftermarket valve. It just needs proper tuning like Scott said. An SSG can help make the rifle a little more efficient...

Sounding like you need to start clipping spring coils as with the springs greater preload when contained within a SSG devise it is over...

Correct they don’t fit the older HM rifles with the smaller regulator thread. Those rifles had a limit on power which is why the...

RAW does sell the entire 35 or 45cc plenum extender as needed and it doesn’t need any other parts. This has all been confusion about...

The extender doesn’t have the same male thread size as the breech block. It won’t screw in.

Yes they do push it out but when you are going for big power with slugs, this is what is required. I helped develop these plenums and we...

I read through the pages for the 35cc and 45cc extenders and the 20cc extension, and they seem very clear to me. I don't see anything...

Yesterday it was blowing air out the reg vent too so I replaced the large o-ring inside the reg. Before I disassembled the reg I...

No, this isn't correct. The 20cc extension needs the 35cc or 45cc to work, but the 35cc and 45cc extenders don't require the 20cc...