Recent content by citojaso

Might be my lack of tech skills but I can't get a single one of those links to work.

If the gun had a moderator I'd make sure it hadn't worked loose. Something easy to check.

Just a wild guess here....if you mounted the scope directly to the rifle I suspect the barrel is not mounted correctly to the action. If you used something like a cantilever mount is it possible it is mounted backwards?

It depends on what you're looking for. If you would be satisfied shooting off of a plastic, folding table that you would find at almost any church social go for it. The only advantage the cabellas table has is the cut out for you to sit in. Personally, I would go to Lowe's and buy a 2ft x 4ft...

I was popping European Sparrows last week and observed a Grey squirrel setting on a fence post calmly eating one.

If anyone here has a true interest in vintage and historic air rifles the Daisy Air Rifle Museum in Rogers, Arkansas is an enjoyable couple of hours. I was amazed when I found out the Louis and Clark Expedition included an air rifle in their armory or that the gunners on WW2 bombers...

Thanks to all who offered their expertise. I soaked everything that had even a hint of corrosion in white vinegar for 24 hours, washed parts in hot water and polished everything with Mother's Mag and Aluminum Polish. Absolutely no corrosion left. I'm amazed at the improvement in my...

Does this new design use 2 or 4 rings on the high pressure piston?

I don't know. Kinda scared to twist it. I can't tell if it's threaded or pressed in.

Can anyone tell me about the part in the red circle. It is on the head of the low pressure side of a TXED012 compressor. I can find nothing that looks like it. My compressor suddenly refuses to go above 250 bar so I figured it was time clean the check valve. I disassembled the high...

They are a blight on the land. They do far more harm than good to the environment

Just making a uninformed guess I would guess it is what it says it is. A South Wind compressor by Stuart Warner.

The cross hair is illuminated with a green dot.

Everything works. Temp goes up to 115° when topping off my m3. Going from 150 bar to 250. I know that's high for such a small amount of time but I have a small water reservoir. If I have to go from zero to 250 I'll use a much larger container.