Chuck-in-Ohio's latest activity
Chuck-in-Ohio replied to the thread FWB Feinwerkbau 800X air rifle cylinder.Same experience as above. The cylinder end pieces are aluminum, and on the fill end the holes to accept the 4 drive pins in the...- Chuck-in-Ohio replied to the thread FWB Feinwerkbau 800X air rifle cylinder.Unless you make the tools yourself, you could have that much invested just setting up to remove the cylinder ends properly. I actually...
- Chuck-in-Ohio reacted to Hobbyman2007's post in the thread FWB Feinwerkbau 800X air rifle cylinder with
Like. Well that’s not good. Here’s a link to a replacement. Doesn’t look to be very expensive. A lot less than I thought it would sell for... - Chuck-in-Ohio reacted to jlharden's post in the thread HW/Weihrauch A little love for the 97K! with Like. I don't give this 97K near enough attention, but every time I do it sure delivers. Others are more challenging to shoot well and perhaps...
- Chuck-in-Ohio reacted to Septicdeath's post in the thread What springer did you shoot today? with Like. Some fun with twins in 22 and 177
- Chuck-in-Ohio replied to the thread FWB Feinwerkbau 800X air rifle cylinder.The OP is located in Macau.
- Chuck-in-Ohio replied to the thread FWB Feinwerkbau 800X air rifle cylinder.Your issue is the that the internal O ring on the cylinder end fitting is leaking. The ring that seals the end cap to the cylinder wall...
- Chuck-in-Ohio replied to the thread Sheridan Sights.That guy is a good egg. I have bought oddball parts from him many times, and it is quality stuff.
- Chuck-in-Ohio replied to the thread What springer did you shoot today?.Weihrauch inserts will not work in that sight. That sight requires the use of inserts that fit an 18mm FWB front sight. The HW inserts...
- Chuck-in-Ohio replied to the thread What springer did you shoot today?.The sights on it look to be correct, I would check it across a chronograph and proceed from there. You were shooting at 10M correct...
- Chuck-in-Ohio reacted to Pellets&Pistons-(Razor62)'s post in the thread HW/Weihrauch Ok Weihrauch Airgunsmiths, I need some advice... HW35 Barrel Latch Worn with Like. Update: The video is before I installed a new spring. I took Motorheads' and Mr. Hateful McNasty's advice and put some tension against...
- Chuck-in-Ohio reacted to cjtamu's post in the thread HW/Weihrauch MK1 HW77 Front Sight Assembly Question with Like. Ron, you’re a genius. Put about 35 shots through it and it stayed locked up. Never used a wicking loctite before and I was NOT prepared...
- “Dry as a popcorn fart.” Man could we use rain. Luckily I pump water out of lake to water garden. Taking these 5 out for a spin today...
- I have a 210 junior and it is absolutely my favorite match rifle. I bought it new, from Champion's Choice. I think it was one of the...
- Chuck-in-Ohio replied to the thread Other Walther 210.What stock configuration did your 210 Jr. Come with, the Ambi stock or is it handed?