Recent content by cfs916

That is a .36l bottle. No, I did not do anything to the bottle. That’s how I received it

That’s not a degassing screw. It’s a plug for the drilled hole. Remove ur gauge slowly and it’ll degass

Here’s the 500mm setup, I have a 385mm as well

Barrel is drilled out to 4.5mm

My current notos with 500mm stx barrel is doing 34 fpe with jsb18gr at 928fps. Reg at 150bar, 67cc plenum volume, all ports drilled out to 4/4.5mm, and 4mm extra spring preload

That sucks. I think FX should start spending some money and having the dealers test these rifles out before sending them to the customers

500mm stx

I have machined a brass adapter to fit a fx barrel into the notos. Here’s my notos with a 500mm stx barrel. I also have one in 380mm as well

Turn down the breech side to 12mm OD and add a internal groove for pellet probe oring

Notos with a Gamo urban barrel

Looking for a fx 380mm stx barrel (not super lite). Only need the barrel housing and the liner but will consider a kit.

If you drill out the hammer and remove about 3mm of material you can get more adjustment on the hammer spring. A 3/8 endmill fits the hammer hole just about perfect

You can get them from rmr. Here’s the link https://www.rmrbullets.com/shop/airgun/25/25-cal-250-slap-airgun-slug-26-grains/

The rifle came with a bag of orings in various sizes. I just picked the one that looked similar for replacement

The original oring was hard and air was coming out of that area. I removed and replaced that and it was still leaking. I’ve just replaced the oring inside the regulator itself and now it seems to be holding air. This was a refurbished rifle I got recently and It was shipped to me without air in it