Recent content by Catman99

Daystate Huntsman Revere regulated 22. Cal. Aztec scope 5.5-25-50 JSB jumbo heavy 18 gr. No wind. 30 yards one pellet per dot. 80 yards 1" circles, started at lower right, second group was with a magazine and they all went to the left so I switched back to single shot tray. Top left...

🐌🐌🐌🐢🐢🐢🐢 most times it won't even let me get on, it says (timed out)

Great job, there is nothing more satisfying as a well organized clean work area. 👍

If we send them back our recycled lead can we get a discount 😉

I removed the bipod mount and adjusted the barrel band so it was not touching the barrel and that tightened the groups right up, what a difference, I was wondering why I could not dial in my scope and the pellets were all over the place. thanks for the help guys👍😊 @30 yards

When shooting powder burner rifles this is not even an issue because the barrel isn't moving anywhere, it's solid steel, its part of the gun and isn't going to flex. This being my first air rifle I'm not familiar with the engineering, design aspects, or harmonics of an air gun so I guess I...

Thanks for all the replies, they are all helpful. As mentioned, if you bump the gun the shroud rattles against the barrel band and that tells us that the barrel has flex and movement, and that movement should change POI. I wonder why they don't put an o-ring between the barrel band and the...

I don't know how thick or ridge these barrels are so that's why I'm asking the below question. When looking at my Daystate Huntsman Revere barrel shroud #42 I notice that it's just floating in the barrel band part #41 and has some movement, if the end of the barrel #24 is attached to the...

I just got everything dialed in, my tank was really low so i just exchanged my bottle for a full one, you are correct it's a 400 psi gauge not very sensitive to low pressure but I got it set, if this 400 psi regulator gives me to much trouble I found a low preasure regulator online that I could...

@elwoodblues I got my pump and nitrogen bottle hooked up today. I replaced the gauge on the right with a 30 psi pressure gauge so I could have better control but it sure is not operating like I think it should, I set the outgoing pressure to 15 psi, the next time I go to use it I slowly crack...

@elwoodblues, I just ordered the same pump, it should be here in a few days. How did you determine that the Psi should be 10-15 psi to feed the pump. Thank you.

So there is an application for using my Nitrogen tank, very interesting. Thanks for the info👍 Do you have to be careful that the nitrogen tank doesn't run out so you don't starve the Compressor.

@elwoodblues. Could you explain how a nitrogen tank would work in tandem with a compressor, I don't understand.

Thanks for that info, the tank is full and I don't use it anymore for refrigeration, I thought it would be an easy change over but oh well, it was a good try. When I looked at the gauge I forgot that we are dealing with PSI and Bar and wasn't thinking that these rifles take such high PSI...

I don't see an advertisement above for a Joe B can you provide a direct link to his website. Thanks. UPDATE: I found it😬it's called TopGun Airguns.