Recent content by CaptainBravo

Hobbyman2007, I think it would be extremely unlikely that aluminum drive gear is unique to the Shoebox. Have you looked on places like McMaster Carr?

Understand, thank you.

1900colt, is the reason you want the hot at the bottom and cold at the top to help the air work out? CB

Thank you.

I don't have a CS4 (hope to soon), but is your picture showing it in it's original position or rotated?

I hope this forum doesn't turn into just vendors trying to sell there stuff. But it sure looks like it in this thread.

Admittedly I haven't used this Caldwell G2 in a while, but I can't get it to connect to my android Note9 (old phone, used with this chrono previously) or S20+ (newer phone never paired before). I've been through all the settings and permissions that I could find. Anyone have any ideas? Thanks...

I don't know what to recommend, but what I would say is if it were me, I would absolutely make sure I could get recreational fuel (completely ethanol free) before I bought a gas compressor. Ethanol causes lots of problems around here. I only run ethanol free in all engines except for the...

I find some of this really funny. I am not trying to be antagonistic, but the right answer for you is the answer that works for you. Not the one that impreses people unless that is one of your criteria. What life has taught me is that for most things, there is no one "right" answer. I have...

MDriskill, That is a better way to say it. I was actually wondering about the sight picture with the peep more than the ability to see through it at all. Given that it is a peep sight, is the magazine high enough to bother you? That still isn't saying it exactly right, but I hope the idea...

SJS, I assume that the peep sight is high enough to clear the magazine, but can you verify? Thanks.

Thanks for the info. I used to do some cad work in Pro/E back when that was a thing. Now the company has switched to Solidworks, but I am in management so I don't have direct access to any 3d software any longer. I've been trying to find software that is both capable, and cheap enough to...

Nicely done. If you don't mind a few questions, did you design them yourself? If so, what software did you use? What printer do you have?

F6Hawk, thank you. Interesting info, isn't the motor rated at 350 watts? So depending on actual input voltage, the rest of the machine uses about the same amount of power as the motor. I wouldn't have expected that, though I have not looked closely at one of these. Not that it really...

I haven't followed this closely, but this is total machine draw from the outlet?