Recent content by Cape Fear Airguns

Hey everyone, Since I was mentioned, just wanted to follow up and mention I am an authorized warranty repair center, so this DRS is coming to good hands. 👍 - Newman

Hey everyone! I know this is a bit late response, but keep a lookout next week for an important update on this matter... 😉

Likely the breech seal. Definitely needs to be replaced. For .30cal, breech seal is 7.5x1.5 NBR 70 The outer seal (around brass inlet) is 10x2 NBR 70, so you should be able to distinguish the size differences easily. For .30 caliber, the factory rifle comes with the 13 gr hammer weight and a...

Hey guys! I don't come on here too often, but happened to stumble across this. Thank you all so much for the support and kind words! I do what I can to help support the community and bring to the table the tools to keep ya'll enjoying your FX rifles! If you ever have a repair question or...

The large grub screw is actually used as a plug. That hole is from drilling out the transfer port in the milling process, so a grub screw with loctite is added to prevent air from escaping there during each shot. It can be tightened down to the barrel, nothing wrong with that at all, but as you...

Hey Guys, Thanks for all the feedback and support, Ernest and I truly appreciate it! We should be restocked within 4-6 weeks, if not faster. There will be plenty to go around when the sleeves arrive. 😁 This new batch will have the 700mm as one solid piece as well 👍 Please shoot me a DM or...

Hey Keith, The .177 liners have a 7mm OD, whereas the .22 liners have a 8mm OD, so unfortunately your idea will not work out. Fortunately, though, the Dreamline Compact barrels will fit onto your Crown, even the "thick" shroud barrels (leave about 1mm of clearance between the barrel and...

Thanks for the photos! I'll try that out next time I come across that situation. 

Unfortunately I personally do not have any knowledge of a release date. doesn't mean there isn't one planned, I just do not personally know about it. Sorry guys! 

They have not been released yet, only digital gauges I know of are the EdGun EDMU gauges 

The silver filings are exactly as you suspect, a sharp edge on the hardened steel spring digging into the aluminum adjuster. You said you did a polish job to the end of the spring, that will probably take care of the filings. With the picture you put in, i can see the ring on the interior of the...

Arnie, Yes, the gauge swap will work. All FX gauges have the same threads, 1/8" BSP. The "smaller silver gauges" such as the Dreamline gauges are 23mm (Uses a 22mm wrench/socket) The gauges that are typically at the end of the airtube, or on the Crown/Royale, are 25mm (uses a thin 11mm...