bubbahotep's latest activity

The output is one way and with a ~2000 psi minimum open. Youd only be saving the air in the hose from filter to tank, the filter would...

~150 years ago, above ~950 fps it helped mitigate lead fouling that would occur. The concern was that mixing a copper round with lead...

When would pressure be left in the filter? I guess if you're tethering to the compressor, but you'd need to depressurize filter before...

Hopefully not too loud for outdoors with moderator. Id want to turn it down for indoors, just fired a few test shots before range day...

Did its skull get seperated from its face?

In the thread on the huben peanut slugs; people were rolling pellets between two files or a razor blade jig to tighten pellet fit.

Theyre adorable until they get into the walls. Wait until landscapers are in the neigborhood making noise and then let loose.

Kyricion moderator and a lighter hammer spring on a Notos and nobody will hear it. Most airguns Ive used are too loud even with...

It doesnt even have a sundial! pfft.

I heard that the fittings arent stainless and will rust if you do this. FWIW the slower yongheng clones dont get above 35C.

Yeah, maybe a teaspoons worth that didnt get blown out or trickled down from pump.

I run a filter afterwards to detect when I need to change the media, need snap ring pliars to reload it or just use the spair. I had a...

My bad. 12v supply is freaking out or the board has a thermal fuse.

Replace the breaker. Look for something like this: https://www.amazon.com/dp/B002SR1U02 Dont re/start pumps under pressure.

To the OP, higher quality rings can justify higher prices by use of better alloy (7075 vs the cheaper 6061) or even moving up to steel...