bubbahotep's latest activity

If noise is a factor bare in mind that many of these airguns being mentioned will need the bark tamed as well.

I'm running a GX filter with a tampon filter afterwards that i check to see if its moist as a sign to change the filter media. It hasnt...

Silica gel on input is pointless. A perfect setup wont even get within 100 degrees of the dewpoint needed.

$265 for Snowpeak T-rex carbine, regulated .22 230cc 3600psi tank, 26fpe/35j @ 900 fps w/ 14.3gr. It's a hunting gun not a dense suburb...

If you got that 50mm spring then I would do the shortest m5 cap head at Ace (m5x8mm like I found) and some 1/4" thin washers to stack (i...

Got my target rifle and targets to be quiet enough that some deer decided to nap in the middle of the range.

Going to try this 9x1x60 mm spring https://www.amazon.com/dp/B09LV363YZ 2-3 week ship time tho. SAE equivalent or cutting down a long...

Cap head screw raised fps to 400, max with washers was 500 fps before sear wouldnt engage. That spring is too small/weak. With the...

Hysteresis, if the plenum is too large the pressure wont drop enough on every shot to open the valve to refill the plenun.

M5 socket head cap screw can slip onto the end of the spring and into the hammer and would add 5mm to the 50mm spring length. Spring can...

50mm spring was too short. Got 250 fps with screw all the way in, screw all the way out was so slow the pellet got stuck in the...

Milk plastic PLA https://www.printables.com/model/756519-target/files

Theres Ebay vendors selling 3d printed pellets. They tend to all look like this.

Dry bike chain lube is wet and dries leaving wax behind. Below 900 fps you dont need to lube to avoid fouling. Above that I would use...