Recent content by bthurman

Apologize for delay in posting been busy in shop. Here is some pics for attaching 4.5 inch MLok low rail on bulldog stock using tnuts. 1. Align rail forward against sling stop and mark holes make sure hole is divided evenly on both halfs of stock. 2. Drill holes in stock making sure to...

Setup this Bulldog Taurus BR build for an AGN member, this was a 357. Machined lower with custom trigger assembly, 28 inch 257 1:10 RH twist hammer forged barrel harmonic balancers between barrel and HM CF shroud, tensioned barrel sytem. New valve assembly machined for the 257. cal. Fore stock...

Filling should have nothing to do with power wheel sticking. It is simple round nut that moves back and forth around valve pin to reduce the stroke on valve. I would still check the valve pin and also check the detent ball for the power wheel to make sure it has not dislodged and stopping power...

Nordicair, The clunk you hear when trying to shoot can be caused by a few items. 1. Hammer spring broken or insuffiecient to open valve. 2. Valve stem is sticking in the speed adjuster, (make sure speed adjuster moves freely and is opend all the way.) 3. Rear of poppet that acts as guide for...

TerryE1- Yes you can put a rail on the for stock of the bulldog we have been doing this for a few years now. I keep the rails in stock along with the mounting hardware. The rail will sit in the middle, and yes there is a seam in the stock but that will not matter for mounting. We use a 5 inch...

RMCIV, I am 3 hrs south from FW off 45, if you get to this area or passing thru look us up. We carry air rifles and ammo in stock give us a call,

RMCIV, what area of Texas?, lots AG folks here. If your about and get near New Waverly look us up. Veradium Air.

Roaro, check the following: 1. Put in dead head turn on water the fire up compressor, check relief valve at to gold cylinders see if you feel air coming from hole in end of it. If so tip Oring needs replacing. Shut down, remove PRV and relace oring. 2. Check to see while running if there is air...

Ezana4ce decided not to pursue a 457 upgrade as the cost to benefit ratio was just not there.

Mercado you are wrong the 308 is an excellent air rifle. The gentleman that owns it, is very happy with the performance and accuracy. You failed to follow instructions and your attempt to Maline my name and work will not be unanswered. He and his wife are great hunters and have taken a lot of...

Ithe bolt in pic is not one of ours, as stated we used to buy these. Then decided to make our own with hiMus cf shafts. We do utilize afuzzy end Imstead of flecthings. Just got tired of replacei them and accuracy has been just as accurate for us as fletched units.

I used to buy these but we now make our own here in our shop. . Out of the Taurus doing 651fps. Had to go with a Himus CF shaft to handle the iimpact, blew a few apart testing but we got it figured out. And yes sucks pulling out of a bag sometimes, try a 4 inch tree trunk just have to laugh and...

Have you tried the non fletched arrows out of your bulldog?

Veradium Air will be releasing a complete line of Evanix Semi Autos the Plus Series. These are exclusive to and only produced thru Veradium Air. New valve and hammer design, increased energy, more efficient semi auto operation., increased accuracy. Look for the official release on July 4th.

My wife and I try to take atleast an hour or two each weekend to let off some steam. She was hesitant at first (powder burner girl) when we first met. She is a darn good shot as well. Gotta love a women with a gun!