Recent content by BobsterIT

Avenger Bullpup

Check the fuse that is at the power plug. If pressure gets too high it will blow that fuse. You can get them on Amazon. https://www.amazon.com/gp/product/B0C6QCDXWX/ref=ox_sc_saved_image_7?smid=AITH7FIDDG9KA&th=1

How should I store my airguns, with air or without air?

I have the same problem on my Airacuda Max. I tried contacting the company 2 times and still no resonce. Does anyone know where I can find instructions on how to fix it myself?

So I got a reply from Hill Support to try and fix my issue of blowing fuses when started under pressure. Hi Bob, The issue you describe is most likely related to some aspect of stage 3 not functioning correctly. If you would feel comfortable doing so, below are instructions on how to access...

The next time I have issues or maintenance I will try to document it with pics

As it turned out I found a o-ring for my stage 3 I had as a spare. Put it in and now compressor is running better than it has in a long while.

When I Started Airgunning I looked at Yong heng Compressors. The impression I got was they were Chinese made and were low quality and HIGH maintenance, so I bit the bullet and bought a Hill EC-3000. As time went on I discovered that the Hill was ONLY for filling guns not tanks. I spent so must $...

you can also order a 50hr rebuild kit from pyramydair

took Compressor apart last night and found that my Stage 3 Piston seal was shridded and there was a lot of rust on the piston. Not sure how that happen. I orderded another set from Hill and when They arrive i will see if that fixes it.

Just did a 50hour maintance on my ec-3000... after about 1hr of fill later I now have the same problem of stalling under pressure restart. so much so as it blew the fuse on the power suppy. I ordered new fuses and I will try to disassemby the compressor over the next few days and inspect for issues.

last time I contacted Hill they sent me parts Free or charge.

Today I received my new Air Venturi 74 CU FT Air Tank I started filling it with a compressor. when is got to about 298 bar it vented a little bit of air as if I had blown a burst disk. What was wierd is after it vented, it went back to filling with no leaks..I know when a burst disk blows thats...

I've had one now for 3 years as well..have had a few issues with it but Hill Support is really good. Just did the 50hr maintance on it over weekend. takes about 1.5 hrs to fill my 45min scba tank from 3000psi to 4400psi

Can someone tell me how to fix the Butt Stock on a Gunnar. Very loose fitting. have tried stuffing paper to tighten it up but doesnt work. Anyone fix thiers?