Recent content by Berto1

Hello I installed the new piston and I can't get pressures above 135bar Notice that the new piston is longer than old one about 0.5mm Someone with the same problem?

In conclusion if i knew what i know today i would not buy the kit, because I ended up buying the huma pin that works for pellets and slugs. so i bought the kit to use only one spacer on my M3 :(

@majorsylvester I totally agree with you no oficial guide to install the slug power kit in the M3 from the FX Europe. So I contact FXUSA an they answer in a short time, and this is ther’s email: quoute: “Yes, just the pin probe and two spacers. The spring is not for the M3, as the M3 spring...

Thank you very much FX

Can any one tell me the factory tune to .22 and .25 please? .22 600mm and .25 700mm barrels. Any help will do.

Need some help here. Can any one tell me the factory tune to .22 and .25 please? I've got the M3 .22 600mm and .25 700mm barrels. Any help will do.

Great data How many shots with the JSB KO? Best regards

1480

$2313,23

Stock reg with problems and speed fluctuations, best spread fps huma - zero problems and 8 FPS spread I contacted Fx suport about the reg problems, like air leakage and speed fluctuation and they sent me a new reg and o-rings. but still, I put a Huma reg

JSB 18 gr 885fps, Huma Reg at 130, Port at .177-.22 Getting 50 shots per fill.

329,91

Any idea!?

The dreamline is new and doesn't have a leake issue. I think the problem is in the gun limitation parts, because law restriction. The gun came with under 17 fpe limitation

Hello. As much as I raise the reg. pressure and the hammer spring it doesn't increase the pellet speed. I'm on 670fps max jsb 18gr. So my question is: It is the gun mechanically limited? what should I do to achieve full factory power? Thanks