Recent content by benj397

1191.40

That would make a great addition. Thanks for the opportunity.

1957.58

A very impressive bullpup. Square shroud is different but I really like it. Winner should also get at least 2 extra mags - didn't see any extras listed. This would be a great addition to my other airguns.

2239.70

Never mind. Operator Error. The pin that prevents the mag from rotating was partially extended into the mag. It still allowed pellets to advance but the mag wouldn't release to remove.

I can’t get the mag out. I think it might be the little pin that protrudes from behind the mag. It has caused a slight issue before but cocking a few times freed it. Now nothing seems to work. I’ve now cocked and shot all the rounds in the mag trying to get it to possibly shift. Now I can’t...

397.77

397.77

1619.32

2019.00

Looking back over the thread, it seems you want to fill guns and small buddy tanks. My early Air Charger can top my Guppy off from around 3500 to 4500 in about 10 minutes. The same amount of time that one would bleed water from the pump. Except you're done. More money for the Turbocharger...

But is it the correct compressor. The feeding compressor for a shoebox must be the oilless type. Any chance of oil getting into the highly compressed gas will not produce a good outcome.

No problem with PCP's in the winter. They aren't like CO2 and the fps changes. For me, I would fill the guns inside a heated space when the guns are at room temperature. Other than that, nothing special to do. 

So, put a little on the swab once or add with each pass? Sorry for all of the questions. Just need clarification.