bchannell's latest activity

I've noticed that mine opens slowly/mildly from what I can tell. It doesn't seem to burst into the gun??

Airgun ING is a hobby that includes working on the guns. If you don't then it'll cost a lot more. A pcp will need work sooner or later...

Wow! Thanks a lot. Awesome info! Mine is the one without the weight so I'm good to go.

Thanks, I've searched and some did...maybe 25, 30 cal, and some apeeared to not have them. Just wanted to be sure.

I accidentally dropped the hammer out of my Crown Mk2. After searching the floor under my bench I found the rear hammer adjuster, the...

Not hard at all 6 screws in the case, pull the cylinder block, then one screw to open the gearbox. I can tear mine down completely and...

Well, from a guy with a Crown Mk2 and, at one time, 10 or so barrels, I can tell you that some barrels just don't get it. Out of more...

Well, I have a Crown (traditional style rifle), a Brk Sniper (semi bullpup), a Dream Tac (pure tactical) and a Wildcat (full bullpup)...

I for one, am delighted with the power increase. I'm a huge Brk fan, their guns are bullet proof and well thought out. No hiccups, no...

Everything we do has some danger, I guess we could all just set in the corner.....but wait, that's unhealthy too🤔

Yeah, it's just a liability issue. It's just not worth it to them. It's much better to sell new ones. Those thread are permanently sealed.

While working on my Crown, the side lever pivot pin just fell out. How was it supposed to be retained in the linkage? It doesn't appear...

Thanks for the help........there's more to the story. The rest of the story. Previous attempts to install the Boss trigger was one I had...

Ok, I've been a gunsmith for a long, long time, both powder burners and airguns. I've tuned, many hundreds of triggers over the years...

It'd probably be cheaper to trade it for what you want. I imagine cutting the bbl will cut off the choke.