bchannell's latest activity
bchannell replied to the thread RTI Rti prophet 2 sping 1&2 specs.1 looks like a ball detent. Any spring that fits the hole would likely work. The other looks like a spring fot the lever. Again try one...- bchannell replied to the thread FX Impact m3 leak from mystery spot ?.Nothing wrong with the new AMP reg's, I don't see any improvement with HUMA, although I do use HUMA, whatever I have available. If I had...
- bchannell replied to the thread FX FX guns WITHOUT POI Shift Issues.I have a Crown mk2, Dream Tac and a Wildcat and no problems. I did have an Impact M3 that suffered from the valve sticking and the first...
- bchannell replied to the thread Will dry air dry out occassional moisture intrusion.I have a set of tools to take the valve off of cf air cylinders such as FX and I'm sure it'll work for many others. Every year or so, I...
- bchannell replied to the thread Pellets verses slugs.I have a Dream Tac 25 that shoots Kings ammmaaaazingly well, and I just can't imagine slugs doing a whole lot more. At 100 yards, it'll...
- bchannell replied to the thread Pellet Groups at 100 yards.I think MOA is a good place to hang your hat. I know it sounds funny, but when I shoot 100 yards, I'm usually shooting off the bed of my...
- I have/had quite a few Hawke scopes and never been disappointed with them. Some Frontiers, Vantage, Sidewinders and Airmax. All have...
- bchannell replied to the thread Jts dead center pellets.I choose them over JSB every time. The 25gr 22 cal shoot fantastic in my rifles
- bchannell replied to the thread FX Wildcat consistency problems.Yes, if I do need to use the screw and dial it in. That is next on the list. I had to mow all day, so the cuts into my shooting time...
- bchannell replied to the thread FX Wildcat consistency problems.Could be, i dunno, some of it looks fine. My question is if I back it down 3-5%, that puts me in the 960 fps range, where the es is much...
- bchannell replied to the thread FX Wildcat consistency problems.OK, I admit my head is hard. I thought I was starting somewhere in the middle and working both ways, but until someone challenged me, it...
- bchannell replied to the thread FX Wildcat consistency problems.Yes, I tried both ways up and down. I've picked spots along the way and went from bottom to top of hammer strike. The hammer is factory...
- bchannell replied to the thread FX Wildcat consistency problems.I've been using a Garmin chrono so I decided to drag out my Crown and try it to verify that's not a problem. I haven't fired the Crown...
- bchannell replied to the thread FX Wildcat consistency problems.Here's the string. I started all new 1st reg at 145 bar, 2nd reg at 105 bar, hammer on 6, screw out one turn. Virtually no change from...
- bchannell replied to the thread FX Wildcat consistency problems.Still trying to move forward. Today, I checked: * the hammer for marks where the sear engages. No marks, it looked like new, and very...