Recent content by Baspinall

Do you eat them? Never heard anyone eating chipmunk unless they were starving.

Hey Neighbor

I assume one of these is what your referring to...

OK - So back to my last question. I guess I mean both. If I already have water introduced to my 45 min. tank from filling without a filter I need a filter between gun when I use it to fill my gun.

So I think I should use an inline tank between my 45 min. fill tank and gun. What in line tanks do you recommend?

Thx for all the replies.I filled mine in about 4.5 hours including breaks. I did notice a decent amount of water when I bled the air before disconnecting the pump. I need to get an inline filter I suppose.

Well, I gave it breaks every 30 minutes. I did the finger in the fluid trick as well :) It's up to 3200 now. So dang hot outside right now I'm going to finish it tomorrow morning.

Anyone using the GX CS4 compressor to fill 45min tanks? I'm filling one right now from empty with this compressor. I know it's a slow process. Been about 35 min so far and it just hit 1000. My question to guys using these is do you run them for a straight 4-5 hours or d you shut them down now...

https://www.mcmaster.com/products/springs/springs-2~/

After measuring "approved slugs" for this gun. Yes, I would need to put slugs from that mold in question through a sizer.

464 seems to be the max height for these mags.

I am. Will need to take that measurement .

I saw that when I looked at the band sizes. Good to know. I guess if I ran them through a sizer that would work? It would size the .462 & .467 rings down correct? Not a huge deal if I don't purchase this mold. I just thought I'd try out casting my own slugs for fun.

If folks are looking for molds this guy has quite a few for sale. https://www.facebook.com/marketplace/item/1942090939505265/?referralSurface=messenger_lightspeed_banner&referralCode=messenger_banner

I found the info on the mold in question so I assume this will not work on an S45. States the driving band is .467 https://leeprecision.com/mold-d-c-45cal-200