Recent content by asgardpark

i checked the video and my probe is the same as the video, tested to switch to .25 withe a huma transferport and it's the same problem the probe don't line up

Hi! My pelletprobe alignment seem to be wrong.. i bought the gun used last year So i dont know so much about it. Anyway the 2 screws on the cockingrod came loose again.. i know i should Loctite them but i forgot to do that last time it happened,so i youtube the problem and watched a couple...

Just found this thread and checked ebay and saw that they where soldout, will you make more ? //Daniel

Thanks that worked perfect! Yeah i supposed to change the gauge to regulator because it s about 40-50bar off but i took the wrong gauge off... didnt get it to seal again when i realised i made a mistake.

Has anyone removed the plastic washer that sits under the pressure gauge on an fx crown mk2? Saw that Utah airguns posted a video on youtube but they just say they uses a torch to deform it and then use a pick to take it out. Can it be done without the torch?

did you check your pellet probe alignment? These screws came lose on my gun so the gun didnt put the pellet all the way in

I got a .25 vp and it came with the 11.5g hammer and a ran out of adjustment ater about 120bar.

did you get it to work and if so did you notice a difference?

i usualy put a little bit of an o-ring between your screw and the metal part

Hmm ok I got the new brass piston installed in the rifle, it's an mkII impact. Do I need to order a different piston for it to work?

Hi! I wonder if anyone can help me identify the pointy regulator screw booth are for the fx impact but with the pointy one I can only go down to about 100bar. The standard one is from my impact and the pointy i ordered as a replacement but it doesn't seems right //Daniel

Will be happy if you share the tune 🙂

Hi I upgraded my mk2 to m3 plenum and when i was going to screw there c1 i was able to screw it in to 5mm by hand and when it was at 6 to 6.5mm it was really loose. When I had the mk2 plenum I had the c1 at 6.2mm, so now i took loctit and set it at the same distance. anyone who had c1 as...

Did some tests on the old valve rod, after I polished it mirror finish, the old pur90 ring does not stick but the brand new one does. Maybe it needs to be used for a while to break in? Talked to fx about it and they said I had regcreep, but I said that the o-ring stuck to the valve stem, they...

Thanks for pointing me in right direction! I managed to solve my issue by changing the pur90 oring to an nbr90. My valve rod had a very rough surface so I polished it and i added a huma hammer weight and huma hammer spring. I also noticed that the valve return spring was in bad condition so i...