Recent content by armando

I own many different pcp rifles including older daystate air wolf, taipan veteran, matador r3m, hw100, hw110, Kalibur cricket, raw hm1000 and I presently also own the daystate revere in 22cal. All I can say is that it is an exceptional pcp. Extremely accurate, backyard friendly with the 0db...

I have the original and the shroud. 

Hello David. Thank you for providing this information to the members. It is appreciated. I own two taipan veterans in both 25 and 22 cal. My question To you is what pellet did you use in your accuracy test and what reg pressure did you have to achieve those groups. Also, the speed. Thank...

Yes it is highly recommended. I used one that cane with my cricket. Insert it and once threaded in use alligator pliers and pull out. You can even put gorilla tape on the top of the pliers as to not scratch anything. If you have the old type of aluminum cleaning rods thst cane in three...

This just a suggestion. Before you take your veteran apart make sure you do a complete string over the chrony. You will gain a wealth of information. For example the speed of your Projectile, the consistency and standard deviation of the string, and the shot count before falling off regulator...

When I received my veteran I proceeded to do the same as you did as I had similar performance. My regulator was marked at the factory with a setting of 152. One complete revolution on the dial reduced the setting to approximately 115 bar. I did a chrony test and at 115 it fell off regulator. ...

What is your regulator set at now after turning it down?

I am in agreement. The taipan veteran is a very good regulator. The parts are extremely well finished. However, I did notice from factory there is over lubrication internally. On my specific .25 veteran I dismantled the regulator and carefully cleaned all lubricants and lightly...

I own a taipan veteran .25 that came from factory at a regulator setting of 152 bar and shooting the 25.4 at 945 ft per second. The shot count was lower than I expected but accuracy was excellent at thirty yards one ragged hole. I reduced the regulator to 132 bar and the velocity to 850 feet per...