AlanMcD's latest activity

Here is some info on water in compressed air I wrote up, and it will help educate you more so you know what you are looking for - two...

I use a hand pump and I believe it is too slow to produce enough moisture to actually get into my guns. I vent the line every 40-50...

OK, but I thought the pain of purchase is short, while the joy of ownership is long . . . ;) Seriously though, I'm not trying to do...

I'll second the sentiment about the ability to potentially stop with a quality springer in the post #25 above. In my case, I bought a...

It is easy to do - you don't even need the check valves in the line, as air pressure is "self balancing" and will flow where needed to...

I'll offer up another alternative, but sticking with the same compressor choice. I do this based on what you seem to be after - knowing...

I'll be responding via PM now

Not to hijack this, but @thammer - could you check and respond to my messages to you on the 3 Groove 16:1 twist Huben barrel you were...

Good question - better to ask than to ignore it and learn the hard way . . . I'd start with two of the posts I wrote in the linked...

Just wondering what you did with the others acquired along the way? What became of the Sidewinder, Daystates, and others?

I agree that ideally you would want to isolate the desiccant from ambient air, as it will pull moisture out of it and reduce its life...

Even if the seller priced it at 10% of what he is asking, the price would be too high. His problem is that while the gun started out as...

Kind of like the arms race. M-Rod folks just have a M-Rod or a few. Not like we bought a FX1, then a FX2, then a FX3 then a FX4 and then...

Close, but not quite - plus calling it "moisture" is kind of confusing in itself, as we really need to differentiate it into the two...

Thanks for the recommendation! In my case, "trackside" is an empty airstrip in the middle of nowhere - autocross events.