Recent content by AirborneB

  1. A

    O RINGS FOR TX200

    Thanks
  2. A

    Pellet Sizes and Fit recommendation

    My apologies. No it is a TX200. That's how new I am. Didn't realize that you actually just shove the pellet straight into the barrel. It just felt hard to push the H&N in.
  3. A

    Pellet Sizes and Fit recommendation

    I have been testing a few pellets and have a question. I have two pellets that are about identical in groups. They are the JSB 8.44grns, .452 and H&N FTT 8.64 grns, 4.50. The difference is the way they load. The JSB pushes in the chamber easily while the H&N takes a bit of effort as they are...
  4. A

    O RINGS FOR TX200

    For those TX200 owners, if you have installed O Rings on the underlever as a buffer, what diameter are you using? Thanks
  5. A

    Oiling

    A AA-TX200 Springer. 
  6. A

    Oiling

    Should I use Ballistol or MP-5 on the under lever link pin to lubricate? And where else to use both of these oils? I bought them to have. Thanks
  7. A

    New TX200 GROUP

    Got it. Thanks.
  8. A

    New TX200 GROUP

    Thanks again to all who provided advice. All advice is greatly appreciated. 
  9. A

    New TX200 GROUP

    Love the gun. Got back from an all day trip and couldn't wait to squeeze off a round. Second mil dot at a empty can of beans at 80yds. Took 5 shots and 5 hits. The gun is amazing. That's why I'm leaving as is.
  10. A

    New TX200 GROUP

    Thanks. I have decided to leave it alone. Why fix what's not broken.
  11. A

    New TX200 GROUP

    As a reminder, this is my first air rifle. But my problem with that is, once I get it apart where to from there. I mean polish what with what? Also lube and flush which part? Lube the trigger? Will that require tearing it down? Are there videos that you can attach? With my luck, I will get it...
  12. A

    TX200 Screw Tightening Specs

    Done. Re-Torqued and they were off a bit resighted. Thanks.
  13. A

    New TX200 GROUP

    Ok then. I will just keep on shooting. I just wasn't sure if a one hole group was the requirement. Certainly am stoked with the gun and accuracy. Thanks again for the advice. Shoot Straight!
  14. A

    TX200 Screw Tightening Specs

    Thanks for the input. For the rear screws(trigger guard) they should be torqued to the same in/lbs?
  15. A

    New TX200 GROUP

    After a day of testing, the TX200 is another JSB 8.44grn 4.52 lover. This is it straight from the factory, no trigger adjustment, no tuning. Just a barrel cleaning. Not bad at all. Now I'm wondering how would it be with a TbT Tuning Kit Drop In??? 25 yards.