Recent content by A&P251

IN

I don’t have one of those compressors to compare the wiring diagram to the real thing. But, if you can get access to the back of the plug and get a picture, I might be able to help.

Thanks for doing this video! I have one of these compressors but have not had to do any maintenance on it yet. I’m sure this will be helpful when I have to tear into it the first time!

Hmm, all my buddies said these things were good for dirt naps… it’s not too comfy though…

Would the type of material make a difference in what wall thickness is needed? I know in my line of work, alloys and heat treating make a big difference in the properties of the aluminum.

I was just given a Toauto A3 for Christmas. So far so good but I’ve only used it once to fill my avenger. I’m going to see if I can buy an warranty on it though. I probably would have gone for a YH or try to get a shoebox set up but when you get a compressor for free, I say just be grateful!

Got it, thanks for clarifying! Any idea on if/when this new special sauce will come out?

Welcome to AGN Miguel! I’m in the Lakeland area as well. Good to know there are other airgunners around here. Most of the good ole Florida boys prefer pb to airguns but I’m working on slowly educating them!

I don’t know a lot about the EVOL line. What is the difference between the standard and the HPS?

Thanks for all the input. It has been a really nice time so far! We have extended family on my wife side of the family up here so much of what we have been doing has been seeing the relatives and enjoying the outdoors. We’ve walked Lake Junaluska, taken the boys down to a little creek at the end...

Too bad, I didn’t get in until later on Sunday. Plus I’m not sure the wife or screaming baby would have liked a detour for a gun show ;) Well, my wife would have liked it… not the kiddo…

Yeah, we’ve seen some of the fall leaves already. It really is beautiful! Haha, I’ve heard from one of our cousins, who used to be in law enforcement in the Asheville area, that the only reason to go to Asheville is to make money. And even then it’s questionable… FL is pretty good on not...

I’m visiting North Carolina this week, normally I’m in the great state or Florida. Is there anything airgun related I should check out while I’m here? I’m in Waynesville which is about 45 minutes west of Asheville.

Sounds like a neat alternative. One that I’m sure a lot of the “I hate electronics” group will like to see. Just out of curiosity, what is the price point?

That’s pretty interesting. I’m familiar with investment casting, although I haven’t done it myself. But, I haven’t seen scope rings that were integral to the receiver before. Looks good! And I imagine there isn’t any fear of it getting knocked off zero.