A.G.R's latest activity
A.G.R replied to the thread Beeman Beeman R-7 .20 cal rebuild….. results….?.No , my tube was actually on the larger side of 25 mm .. That being said Tom changes the kits so often that the spring you have may not...- A.G.R replied to the thread Beeman Beeman R-7 .20 cal rebuild….. results….?.It may get 10 fps. But it sure is hell is not gonna get 70. If the seals snug. Was the Vac seal snug? It needs to be on the fine...
- A.G.R replied to the thread Beeman Beeman R-7 .20 cal rebuild….. results….?.I’ve got a R-7 .20 with a Vortek pg4 and it’s a hammer. Seal sizing is key with them as well as lube removal in the inner springs...
- A.G.R replied to the thread Hatsan Hatsan 95 trigger broken part?.Brass bushing is fine. The whole floating front half moon was a poor design they added fire wards WHY .. ITS USELESS BEDROCK BOB HAS...
- A.G.R replied to the thread Hatsan Hatsan 95 trigger broken part?.Spring is not needed.
- A.G.R replied to the thread Hatsan Hatsan 95 trigger broken part?.That’s a original Quatro. The pin is 5 mm iirc. It’s the same diameter as the broken piece you have. You need it to be C clipped in or...
- A.G.R replied to the thread Hatsan Hatsan 95 trigger broken part?.It’s a common known issue , no one has had it happen more than Bedrock Bob. He shoots 3000 a week, from many Hatsans. He has had them...
- I made one before. I have the old one somewhere, somewhere, somewhere............................. I'll look when I can
- A.G.R replied to the thread Traditional Rifle Webley Tomahawk Turkish made .177 Quatro trigger..This listing has been renewed
- A.G.R replied to the thread HW/Weihrauch MK1 HW77 Front Sight Assembly Question.Usually there is a small dovetail that is milled onnthe barrel that the front assembly locks onto. Some also had spline pressed fit...
- A.G.R replied to the thread Traditional Rifle Webley Tomahawk Turkish made .177 Quatro trigger..This listing has been renewed
- A.G.R replied to the thread HW/Weihrauch HW50 , the challenge continues.In order form that barrel to work well and be level. Your gonna need to remove some from the under side of the detent area you can see...
- A.G.R replied to the thread HW/Weihrauch HW50 , the challenge continues.Raising the sight will never correct the issue at hand. The breech block is misfit. Not original. Many older guns don’t fit newer...
- A.G.R replied to the thread HW/Weihrauch HW50 , the challenge continues.That’s breech hang up. The bottom area under the block need to be filed to let it drop to level it as well as may have to relieve the...
- A.G.R replied to the thread Beeman Beeman r7 in uk.Goo Nice mod, you always impress … The 20 cal R7 , (Königen) you have seen it that’s a tad snappy with the Vortek kit in it. It’s at 8...
