6gun's latest activity

Any power mods to this I have almost the same build but in 22 and looking into the dual hole transfer port and a stx barrel allready...

Nah... Just open her up and turn down the reg to your desired speed. Just turn out the hammer spring cap all the way back and see where...

You'd be buying a a factory one or doping the drilled one with welds or tungsten. I would recommend finding a factory one to play with...

My friends and I have done a little research on how little gun you need for backyard rodent head shots with weak antique guns ends up...

If you are using a Hollow Point pellet that will expand you may still be able to get a one shot humane kill without the full...

I have been after this destructive critter for most of the summer, he has been carving jack o lanterns out of season 😠 A helpful...

I dont mind the look of hardcoat ano just because it tends to stay that way and doesn't usually purple up. I really enjoy the idea...

let me just say this. since this gun was released, it has the same issue as the M3 does with warming up. I've seen and witnessed...

I dont know which variable did it, but my 1st shot being unacceptably low (where poi was a deal breaker) ended when I did dual huma regs...

I just completed assembling three of the prettiest magazines I’ve ever built. Recently receiving my first shipment from the aluminum...

There is a long thread on this issue. Find that and study it

It is normal for the M4 and very very Sad ! :cry:

As an impact owner myself, welcome to known impact issues. It can be less problematic if you tune it in a specific way.

Depending on what your crosman 177 was, bring it down to the 4-600 fps range depending on pellet used. (those are the speeds I remember...

It may just need the reeds or check valves cleaned. Otherwise a rebuild shouldn't be too terrible.