6gun's latest activity

You make a filling station...

Btw I'm sending the 34 javelin at 990 on power wheel 10 micro is somewhere near the lower end of the middle. That was just the speed...

You're on the right track, I have the exact same gun. I hit a plateau a few bar higher than you but I was chasing a heavier slug with...

I have a question about the tuning of my FX M3 22 caliber 700 mm sniper. I have gone through the tuning that was recommended by quite a...

Hey at least it's flexible and bounces back!

More like rubbery in my case.

I have to get acquainted with the general off topic discussion sub forum here. I have so many questions. Live steam is something my...

Here's a link to a discussion about clear coating brass. I've made a cool steam engine or two...

It's even really bad in the southern part of the state. Parks, homes, hillsides. Recently I was brought back to old Crosman stuff...

American Air Arms EVOL .30 NSA’s 49.5s and Zan 54s. Shots taken from 30 to 75 yards. Let’s put ourselves out there and help our local...

I use the smaller square ones that are a single weaver groove each on one of my rimfire. An excellent way to convert an existing scope...

Hi. I found this 11 mm to 20 mm base adapter on Amazon. It is low profile and just snap onto your scope ring base and snug it down. It...

I will agree with the clear coat idea but suggest an alkalyd. Only because I can speak to it's durability. If you have an air brush it...

I had a black parco survival 22 with the built in foot pump.. I got it scratched up and I saw it was brass underneath the flat black...

How is the rear sight attached? Just tight press fit? Can it be removed to clean under and close to it?