Recent content by 3DAirgunWorks

instruction are over in the Discord group.

So far the M5StickC has been the most user friendly to setup.

Press fit hard plastic case going into flex tube that stretches slightly to hold tight. Also no screws needed for the picatinny. It is flex filament and press fits/snaps on.

Rough draft based on ideas from the group. Once I get my little magnets I will post the file. I will also work on a battery backpack

If someone tries to sell for $100, I will leverage the power of my 3d print FB group to flood the market with them at cost. We have almost 5k members in the group. Let’s see if anyone wants the challenge.

@Hallyster61 can you remix the folding arm into it? If not, I can. Just dont want to steal your work.

You had to one up me with a better more simple design. lol.. nice work. thanks for sharing. I just ordered some small magnets.

so sitting on top in front of the turret. I will work on one this weekend. My side-shot scope cam mount is in the way for me, but I can design it for others.

https://www.anarchyoutdoors.com/send-it-electronic-levels/

@fe7565 can we add a separate project for the M5StickC Plus? Anti-cant meter and level. There is a built in gyro we could use. Have a simple screen with 5 lights. Red Red Green Red Red. Similar to the pic below. Another $220 item we can make for $20. @DaystateRebel what do you think?

what size magnets so I can order some?

draw a sketch with the dimensions and I will post a design you can have printed.

Made a TPU (flex material) back that snaps onto picatinny rail. Front cover is still printed in hard material (PLA/PETG).