Recent content by 1911addict

The goal is to obtain as much consistent power as possible to be able to further test slug weight and diameter to either work in a rimfire barrel or my RAW original barrel. As far as rimfire accuracy the biggest issue is always ammo inconsistencies-maybe a snipe hunt with air but I guess I like...

I have been a 22 benchrest shooter for over a decade and am aware of the differences in power between the two platforms. I purchased the RAW to get into the air rifle sport, shot and tested some pellets with good success but since a heavier projectile will help in the wind ( and I think pellets...

I should of mentioned I have already switched barrels to a .22 rimfire.

I'm looking to upgrade my RAW 1000 HM 1000x to shoot 50 yards (31.2gr slugs). I have reached a limit on its power (approximately 700 fps) with hammer and regulator maxed out at 225 bar. Updated mods (hammer, springs, regulator,plenum possibly, needle valve,etc.) Part or tuner recommendedations...

Besides going back to RAW does anyone do a drop in for them or does someone get the blank and have it machinied? Thanks 

I was looking at heavier pellets for 50 yards and to help buck the wind but I'll try these weights. I assume you're barrel is also choked? Do you match the slug more to the breech size or the choked size,? I shoot .22 benchrest and really don't like choked barrels. Thanks 

Thanks 

In the process of sizing and preparation of pellets/slugs for best accuracy what is the general consensus of pellet size to bore size?

Thanks for all the info.

What diam. are you using 

I would like to see a few pictures of the dies and what size,weights of slugs you are making 

I shoot a RAW 1000 .22 and want to try slugs. What is the recommended brand/smple pack to start with?

Looking for airgun shooting groups in the Va/Nc area to join. Please contact me [email protected]. Thanks