1900colt's latest activity
1900colt replied to the thread Gx cs4 air compressor.You don't need to change all the water out, but remove at least half to 3/4 of what's in that water tank and replace with water wetter...- 1900colt replied to the thread Gx cs4 air compressor.Just be sure to use something like water wetter or antifreeze mixed with it. Straight distilled water will cause corrosion over time.
- 1900colt replied to the thread CS4i issue.It's the part that is attached to the top of the cylinder head with a Phillips screw. Follow the wire to where it's going to either be...
- 👍🏻thanks!
- 1900colt replied to the thread O-rings for GX compressor.They will be on ebay, or just call/email the contact info on the website. We will be putting some kits together tomorrow. Everything...
- 1900colt replied to the thread O-rings for GX compressor.I have a few put together that I'll be taking to the Indiana show. They are for replacing the low pressure seal. They will not be...
- 1900colt replied to the thread O-rings for GX compressor.Gx accessories page. They have the full kit https://gxpumpofficial.com/?ref=BBSGLLC
- 1900colt replied to the thread How to cool a cs4 or cs4-i, even better than just bleeding the air pocket..It can easily drop temps that much. Glad you tried it!!
- 1900colt reacted to peebrainz's post in the thread How to cool a cs4 or cs4-i, even better than just bleeding the air pocket. with
Like. I just rotated mine and all I have to say is wow. I must have had an air pocket because I’m running like 20+ degrees cooler now. - 1900colt replied to the thread New GX filter is coming out!.The first shipment will be here next month
- 1900colt replied to the thread CS4i issue.The check valve on top could also need cleaning out and be sure the spring is in correctly. Loose wires to the board can do it as well
- 1900colt reacted to Grey-Kiwi's post in the thread How to cool a cs4 or cs4-i, even better than just bleeding the air pocket. with Like. Just did mine about 1/2 an hour ago. Mine is the CS4-i model so maybe a slight difference in the fan wire length? Anyway, the sliding...
- 1900colt replied to the thread How to cool a cs4 or cs4-i, even better than just bleeding the air pocket..Correct. Also the temps stay about the same in either position.
- 1900colt replied to the thread GX-CS3-I question.Glad it worked out!
- 1900colt replied to the thread How to cool a cs4 or cs4-i, even better than just bleeding the air pocket..You can tell the whole radiator is being used in this position by using a laser thermometer on the opposite side. Or just touch it...