My question was only because I use usual BR100Y targets size like on Rocky Mountain Airgun Challenge or Extreme Benchrest - just to understand the size. Thank you for the information. Very good results. What Panthera setup and adjustments do you use?
I have made these targets long time ago, and printed 1000 of them. I'm still using them. 29.1mm comes from one MOA @ 100meters.
It's probably similar to your targets.
I have the gun at 150 bar. Replaced the piston part of the regulator few weeks ago because it was creeping. Now it's extremely consistent. Far more consistent compared to my other FX guns.
We have four Panthera's at the range, and we try to figure out the same things to compare the best results.
Micro is at 3.25ish. Most FX guns like the tune at that point where it just reaches the right speed. The Panthera seems to like a bit more hammer.
We shoot H&N 34 grain .218 and Javelins 34 grain .218.
We have tried .217's but the results were overall worse.
We can't get the ZAN's 33grain to shoot well.
Speed is around 990 tot 995fps.
Got the carbon sleeve installed last week. That made a difference. You never know where those bloody Orings are when you install the Liner. And I just hate taped solutions to keep them in place.
I clean the barrel with ballistol after every shoot. And I don't take the liner out anymore.
I have tried to leave the spacer out of the shroud, but the bullits clipped the muzzle adapter on the front of the shroud. I will mill that part down to a bigger size soon.
We are not alowed to rest the gun on the back on a sandbag. So I have made a kind of a click on stock.
at 100m with the panthera inside and outside. Bipod Only, nothing on the back but my hands.
