Your problems, a hobby is a problem? how about putting up with the BS of life that makes us old, if life was that easy harry
Upvote 0
- The AGN App is ready! Search "Airgun Nation" in your App store. To compliment this new tech we've assigned the "Threads" Feed & "Dark" Mode. To revert back click HERE.
Help me find some bottle heat shrink wrap 60mm + ?
- Thread starter Goldwing
- Start date
Your problems, a hobby is a problem? how about putting up with the BS of life that makes us old, if life was that easy harry
Upvote 0
The member 2 years ago only used the 50mm and got it on, without the use of sex lube
Ask him to chime in
Heat shrinking rubber for barrel protection and carbon fiber bottle cover FX.
Ask him to chime in
Heat shrinking rubber for barrel protection and carbon fiber bottle cover FX.
Upvote 0
I was the guy who posted this that's my impact in the photos Ernest Rowe and me both used the 50mm for the 580cc carbon fiber bottle yes it's hard to fit on but it's very doable lots of members have already done it as well as myself I put a little silicone grease spray on the inside of the sleeve or on the bottle.
Upvote 0
I got the tubing from Amazon today, will remove the bottle and apply the silicone spray and try to slip it on from the vulva side and see how it goes this time
Upvote 0
I got the tubing from Amazon today, will remove the bottle and apply the silicone spray and try to slip it on from the vulva side and see how it goes this time
This is the best way to get it...
Upvote 0
If the pattern is all you are concerned about, taking your bottle and a sample of the pattern to a shop that does vinyl wrap.
Upvote 0
Did you get it with the silicone spray? Here's a few alternative ways it may work out for you...
If you degass and then put the bottle in the freezer it will shrink some. Warming the shrink tube in water should allow it to stretch over also.
We use hair spray for applying motorcycle grips on bars, and it works great. Spray the inside of the tube so it is soaked and stays wet then slide it on, and position it easily while wet.
If you degass and then put the bottle in the freezer it will shrink some. Warming the shrink tube in water should allow it to stretch over also.
We use hair spray for applying motorcycle grips on bars, and it works great. Spray the inside of the tube so it is soaked and stays wet then slide it on, and position it easily while wet.
Upvote 0
Spray silicone inside the tubing as well as the outside of the tank it's also better with gloves to grip.
Upvote 0
Using leather welding glove to grip, yes both in and out on the silicon, will do the trail biasing and than the bastard will come out with 80mm with a pattern that all you have to do is slip it on and slightly heat it up
This sucks, see you in a week...........
Upvote 0
Member here showed this off, me likey
https://www.gunskins.com/products/rifle-scope-skin-bundle
Dubs71 Member gunskin job
https://www.gunskins.com/products/rifle-scope-skin-bundle
Dubs71 Member gunskin job
Upvote 0
You believe if the cylinder is empty then the heat shrink would go on?
I can't believe the bottle would change dimensions enough to achieve getting the shrink on by say a few fraction of inch
Upvote 0