Sinclair Bi-pod

Well the Sinclair F-Class bipod arrived today well actually about 6:30, post,an was running way behind but anyway I assembled the bipod and it is a Beast but a nice Beast to say the least, outside pad to outside pad is 16.50” inches, this thing is solid and if mounted right it’s going to make your muzzle end of the rifle rock solid, or was to late to try it out on one of my Airguns but tomorrow I’ll mount it up to the wildcat and do some shooting,can’t wait to get it on my HMx LRT when I get it, I will mount it on my HMx 357 next week and see how it does..I think I found a new rest for my 6.5 Creedmoor target rifle. Her is a pic of it on a oven mit just so you get a idea of how big it is.

I’ll get better pics tomorrow when it’s lighter out and I have it mounted.

I thought I had my BT65SB Elite QE at home which would of been a better airgun to mount the Sinclair to but I did put it on the wildcat just to see what it looked like. I throw a pic up in a few minutes. It’s not designed for a bullpup but here are a couple quick pics.

I had to use a picatinny swivel stud adapter being the wildcat doesn’t have a swivel stud so it sits a bit high off the bipod.

I like it and it’s well made but I still need to get used to how wide the foot print is, I had to cut a piece of plywood and put on my new MTM shooting table being the Sinclair is just as wide, it will be fine out at my range with the big table where I have the space for it.
I guess my only complaint is that you need to remove it when you put your rifle in the case or cabinet other then that it’s nice and the fewer moving parts the better.

I’ll get a pic of it on my HMx later.