Just Ordered My Flex .30!

"sniperlabyo"BTB thanks for the inputs"


Yes, the hammer is free floating about 3/8"----its 3" OAL wire size .062, with this spring I can go up to 950fps with 25g

yes the reg has a creep and must be the older one, it will shoot about 8 fps faster when it stop creeping--I say around 10b.

on the photo is the threaded block labeled in red. when this block is bottom tight it will force the shroud so high that you cant screw the breech/barrel on.so you have to back it off till the flat side of the block is squre with shroud--now you got a wobbly bottle.


You should not tighten down the block all the way to the short tube its suppose to be 1-2 threads shy for clocking the drop down .This was told to me by travis when i replaced my seal I blew when I accidently over filled it.Ernest you should talk To Travis before you dive into his products hes very generous with his time and I find him to be down to earth. Sounds to me like your customer was messing with the adjustments and couldnt get it right. Good thing guys like you are around who know alot about these things. Keep up the good work.

Click to expand...

"Terryb00"Airkrazy,
is that a Donnyfl LDC on the end of your Flex?

Click to expand...

"TimTebow"

You should not tighten down the block all the way to the short tube its suppose to be 1-2 threads shy for clocking the drop down .This was told to me by travis when i replaced my seal I blew when I accidently over filled it.Ernest you should talk To Travis before you dive into his products hes very generous with his time and I find him to be down to earth. Sounds to me like your customer was messing with the adjustments and couldnt get it right. Good thing guys like you are around who know alot about these things. Keep up the good work.

Click to expand...

Tim,
From Ernest's post it seems that he is using a shim to "clock" the drop down. He posted that without the shim, and not fully seated, it would move up and down.
Not sure how this would happen with 130b on the connection (I know mine does not move, and it is a full 1/8" from the shroud. I think you could be right with the assessment of customer "messing" with it. Other then turning the HS screw (and replacing the Regulator Piston), I'm not sure how much more "tuning" would be needed.

the results is a bottle that can flex up or down while pressurize and touch the shroud, I place a shim so that all 3 parts can be tightened down and centered.to give proper clearance with the shroud and bottle.

Click to expand...