Previous

Cricket .35 parts

Forums PCP Airguns Cricket .35 parts

Viewing 6 posts - 1 through 6 (of 6 total)
  • Views : 224
  • Link
    Profile photo of Stan
    stan
    Participant
    Member

    Is there any kalibr dealers around I need parts for my cricket .35 
    hinge pin from cocking lever to probe snapped,probe spacer turned sideways bent cocking lever and galled action a little.
    called a couple of people who wished me luck bummer. Being from hawaii just makes it tougher
    any advise would be awsome
    The pigs and deer are happy though lol 

    Link
    Profile photo of intenseaty22
    intenseaty22
    Participant
    Member

    Only dealer I know is Charlie Frear / GA Airguns. Google him and give him a call. No promises since I don’t know if he can help you, especially that far out. I know there are other dealers out there, but have never looked around at others. 

    Did you reach out to AoA? They are a little closer to you. I know they sell the .35, but don’t know if they can provide parts as well. Can’t hurt to try. 

    Good luck

    Link
    Profile photo of sirk
    sirk
    Participant
    Member

    Hi, how did you get the pin out, i read it is not possible without damaging the action. Let us know how are you getting on with the repair.
    Was one of the reasons for Sniperqty to swear that much

    • This reply was modified 1 week ago by sirk.
    Link
    Profile photo of born agian
    alex2865
    Participant
    Member

    charlie is the guy on parts and tuning for the crikit.alex

    Link
    Profile photo of Stan
    stan
    Participant
    Member

    Thank you for responding
    I contacted Charlie, awesome person,  he has all the parts I need.

    intenseaty22  Yes I tried AOA  said they might have one of the parts and will call me back.

    sirk  I’m not sure which pin your asking about but the pin from cocking lever to probe is a slip fit but there one pin that looks like its press fit which holds a part for the sear. I didn’t need to remove that area of the action.

    now the only problem i’m having is removing the pin holding the cocking lever its in a blind hole, should be a slip fit but won’t slide out !!?

    again thank you for the info stan
              

    Link
    Profile photo of Tom
    Long_Shot
    Participant
    Member

    I was trying to remove that cocking lever pin recently on my .35. Unable to remove it. 
    Should have a hardened threaded fastener instead of a recessed pin with no reasonable way to remove it. 
    Kalibrgun screwed up on this design. 
    If mine breaks I’ll bore it out, tap the receiver and install a fastener. 
    I sure wouldn’t put the stock pin back in it………..

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.