If anyone has one I need some measurements please. I have a RWS 34 that I'd like to put in a thumb hole stock and if the Titan GP stock could be made to work I'd give it a try.
Thanks
Thanks
Benjamin Titan GP, anyone have one?
- Thread starter 1BadDart
- Start date
pretty sure I have one, I actually just took it off the wall this morning and was thinking of taking it apart and tuning (not like I don't have 10 other projects ahead of it...). I'll take it apart and take some pictures with the caliper this week when I get a chance.
Nice Dart btw - 426 by chance??
Nice Dart btw - 426 by chance??
Upvote 0
The Titan compression tube is most likely 26MM and Diana is 28MM so you need to remove quite a bit wood. Could be done though I'm sure...
James from Michigan,
James from Michigan,
Upvote 0
Jeff the Dart has a 434" Indy headed small block in it.
John I need the width of the stock across the air chamber inlet, the distance from the front screw in the trigger guard to the action screws in the sides of the fore end. Also the distance to both ends of the air chamber inlet from the front screw in the trigger guard. I hope this clear.
Thanks, Justin
John I need the width of the stock across the air chamber inlet, the distance from the front screw in the trigger guard to the action screws in the sides of the fore end. Also the distance to both ends of the air chamber inlet from the front screw in the trigger guard. I hope this clear.
Thanks, Justin
Upvote 0