You can 3d print a C1 tool as well that way you don't have to pay $40 for the most simple device on the planet.It's not as bad as you think. Highly recommend picking up Ernest's C1 tool from 910 Airgun Tuning and Repairs. That and a good set of metric hex drivers. Also will need a set of vise grips wrapped in tape for clamping down on your valve rod. There are several videos on YouTube.
But you would have to buy a 3d printer and the resin? I'm thinking I'm fine with the $40You can 3d print a C1 tool as well that way you don't have to pay $40 for the most simple device on the planet.
Don't have a friend with one?But you would have to buy a 3d printer and the resin? I'm thinking I'm fine with the $40
How hard is it to install a tungsten hammer weight on an impact?