So, I have an Impact in .22 with the high cap 28 round magazine. I also have a 3D printer. So, I found a speed loader file on the internet and printed some. Didn't like the design. Then I found another design and printed some speed loaders. Didn't like the design.
Finally found a design I like.
To be clear, they all work. My problem in design is lid. The lids just sit on top of the loader, and are easily spilled. I found out you can fit two loaders in a JSB tin, and get the lid to close which keeps them from spilling. The design I like uses magnets to keep it closed and I LIKE that design.
So, in the end, I have 22 speed loaders I won't use. I hate to throw them out, but not sure how best to dispose of them. Where people are selling these things (some are the same design that I printed) for $20 or $25 each I hate to let them just sit.
Thoughts?
Finally found a design I like.
To be clear, they all work. My problem in design is lid. The lids just sit on top of the loader, and are easily spilled. I found out you can fit two loaders in a JSB tin, and get the lid to close which keeps them from spilling. The design I like uses magnets to keep it closed and I LIKE that design.
So, in the end, I have 22 speed loaders I won't use. I hate to throw them out, but not sure how best to dispose of them. Where people are selling these things (some are the same design that I printed) for $20 or $25 each I hate to let them just sit.
Thoughts?