- The AGN App is ready! Search "Airgun Nation" in your App store. To compliment this new tech we've assigned the "Threads" Feed & "Dark" Mode. To revert back click HERE.
Airgun Technologies Switching side lever..
- Thread starter cosmic
- Start date
Got to unscrew axis pin, too, after removing pinching screw. In my Uragan 2 Manual (Page 7) pinching screw (#60) removed first, then axis (#107) unscrewed next. WM
Upvote 0
Hole is threaded, axis pin is smooth for arm to pivot just has threads top 1/3, or so. Is it possible axis pin turned wrong way and fell in towards gun, past threads? If so, need to wedge up gently, while unscrewing, in order to "catch" threads.
Upvote 0
Bottom of axis pin rotates in an indentation in the frame, not attached, the threads on top and the pinching screw hold it in place.
Upvote 0
Got it done and Thanks.. Next is the plenum switch from low to high plenum capacity .. A video would be nice..
Upvote 0
Search AGN archives for, "AGT Vulcan 3 Reverse Air Chamber How-To," by oOmph on 9/10/22. Zx10WALL links a helpful diagram, a post, or two, in on this thread. (Upper right corner type in thread title and "oOmph" in member section, then hit Search button.) WM
Upvote 0
Check out my previous post, should have replied this way first, that way you'd be notified of another message.
Upvote 0