Regulator Re-seal

[MobyMyster]

The HUMA regulator in my BSA Ultra SE crapped out & I need to get it resealed.

I don't have the tools myself so need to send to someone who does.

Who's doing this kind of repairs....?

TIA,

MobyMyster

 

[L.Leon]

Reach out to @motorhead, he might be able to help. Very savvy and well known air gunsmith.

 

[hawkeye69]

You should be able to do it without any special tools. It's simply replacing the O-rings with new ones. Huma sells a kit.

 

[nervoustrig]

Super easy. The only special tool you need is something to remove the snap ring. A pair of jeweler's needle-nose pliers may work in a pinch.

 

[jwrabbit123]

only need a screwdriver and a snap-ring pliers or a fine point needle nose , I run huma in all my pcp guns and usually only failure I have is either orings there is 2 which fail or tiny port gets clogged or debris gets between white delron seat , it will take u literately 10 minutes to do it just keep things clean and if you remove the washers look how they are orientated or keep in order pm me if u have any problems , ps huma sells rebuilding kits for like 10 bucks with all parts and grease to lube things up

LOU

 

[MobyMyster]

Thanks you guys - good info all around.

The "snap ring" way down inside the valve body is the main problem.

Think I'll pick up a pair of jewelers needle nose pliers & if I can get that snap ring out.

Tks again all...

Moby