The .177 mags had no problems, my .22 mags problems. Every pellet would jam. Exit port had to be deburred/chamfer added/polished and now its loads smoothly.
Look at the bite on this JSB dome.
Look at the bite on this JSB dome.
Upvote 0
PP750 finally arrived and Artemis Pistols Nirvana!
- Thread starter qball
- Start date
Are you guys ordering directly from Brian, or do you need to have it shipped from Wes to Brian, or what?
Upvote 0
I ordered mine from Wes and he sent it to Brian who then shipped it to me when he was done with it.
Upvote 0
The .177 mags had no problems, my .22 mags problems. Every pellet would jam. Exit port had to be deburred/chamfer added/polished and now its loads smoothly.
Look at the bite on this JSB dome.
thanks for the info, going to take apart mine and do the same. Mine jams often.
Upvote 0
First blood for the PP750, house sparrow for breakfast! Great way to start a morning!
this house sparrow has been quit smart and eluded me for a few days, as soon as it seems me it would Hightail out flying fast and low. This morning I grabbed the PP750 and waited at corner my house and it made the mistake of not seeing me.
this house sparrow has been quit smart and eluded me for a few days, as soon as it seems me it would Hightail out flying fast and low. This morning I grabbed the PP750 and waited at corner my house and it made the mistake of not seeing me.
Upvote 0
By any chance can some one tell me the diameter of the rods used for the stock?
Thanks,
Bryan
Thanks,
Bryan
Upvote 0
"By any chance can some one tell me the diameter of the rods used for the stock?
Thanks,
Bryan"
In answer to your question, Yes, of course, any 750 owner can provide you with this information! I hope this helps!!!
No need for thanks! I'm just pleased I could help.
Kindly 'Ol Uncle Hoot
PS: By the way it's 5.98mm, yuk yuk yuk!!!
Thanks,
Bryan"
In answer to your question, Yes, of course, any 750 owner can provide you with this information! I hope this helps!!!
No need for thanks! I'm just pleased I could help.
Kindly 'Ol Uncle Hoot
PS: By the way it's 5.98mm, yuk yuk yuk!!!
Upvote 0
Speaking of 6mm, I have some washers for the pp750 shroud. They are 19x6 mm. for guys that don't have a lathe. I also have some lighter hammer springs for the pp750. Check the classifieds. Loving my 750, and hope you are too. NIRVANA for sure !
Upvote 0