Impact MKII Huma regulator.

[Lewis]

Does anyone know which regulator would fit the MKII Impact?

The Huma site says the following but I don't know if "current" was before the MKII. 



"Gen 3 : Factory regulator with a 16 mm long polymere piston and 10 mm diameter belleville springs (current model)"

Mod Edit: Moved to PCP Airguns forum

 

[Birdslayer25]

Yeah it will fit the mkll. Just make sure you get the 16mm version. I talked to a feller at Trenier outdoors he sell the Huma regs. I called to confirm with him. My impact mkll reg is creeping around 10 bar over a 1 day period. I’m gonna get the Huma if it don’t start getting settled in. Do you have the same problem 

 

[Lewis]

Sort of...

Mine will creep about 5 bar overnight if set to 150 bar at 140 it does not creep. Go figure.

 

[mtnGhost]

5 bar is not really creep, it's likely changes in temperature and/or atmospheric pressure. I have the same regulator in both of my Crowns, it only creeps on the rare occasions that I set them up at 180bar, where it will jump a little over 190. I have one of the extra-high Huma refs ready to install if it does start to creep in my 700mm Crown at lower pressures, but so far so good  

 

[Birdslayer25]

I wonder if I took out one or 2 disks if that would stop my reg from creeping?

 

[Mikepr]

I wonder if I took out one or 2 disks if that would stop my reg from creeping?

Nothing to do with creep !
Only the pressure decrease about 20-25 bar

 

[Birdslayer25]

I wonder if I took out one or 2 disks if that would stop my reg from creeping?

Nothing to do with creep !
Only the pressure decrease about 20-25 bar

I thought it might allow the piston to seal of better with less resistance 

 

[Mikepr]

I wonder if I took out one or 2 disks if that would stop my reg from creeping?

Nothing to do with creep !
Only the pressure decrease about 20-25 bar

I thought it might allow the piston to seal of better with less resistance

Absolutely not !

first change orings

 

[Birdslayer25]