Interesting info. Now that I have a lathe, I really need to make one of those pin probes. I only shoot slugs, so it should work well.
As for the transfer port, it would be nice if these were available blank, so you could custom machine your own opening. I just sent Huma a message to see if that's something they would consider.
I'm also trying to decide if there would be any harm to having an extra hole. For example, you could start with the stock FX part, turned it 180 degrees, then made a new notch, and cut the new port. That would leave the stock port on the opposite side, but the o-rings on either end should prevent that from being a problem.
Rusty
You have a lathe so you can make the blank ones. Leaded Naval brass turns like butter.
Upvote 0