FX Impact Trigger Problem

[TJE]

I pulled the trigger from my Impact to install a HUMA Regulator. When I reinstalled the trigger, the little Pac-Man character will not move enough to release the sear pin. Prior to removing the trigger assembly, everything was working fine. I have tried adjusting the adjustment screws without results. Any help or advice would be greatly appreciated.

Thanks,

Tom

 

[elh0102]

I don't own an Impact, but the drawing appears to show the safety close to the reg. Could it have been moved to a position that prevents fully disengaging?

 

[Funshine]

TJE, I am not sure if this will help you, but check that the regulator is screwed in properly. Sometimes the trigger assembly hit the Reg screw and prevent it from lining up and even firing. Stay safe

 

[TJE]

Thanks for the help. I was being to careful not to over tighten the regulator. Just a half turn did the trick.

Tom

 

[Funshine]

I am glad that it solved your issue, now happy shooting and stay safe.